Cobra CM2208 2000KV

New product

Cobra CM2208 2000KV

More details

This product is no longer in stock

Subscribe To When In Stock
You have successfully subscribed to this product




Shipping Rates

More info

The Cobra CM-2208 series motors have a 3.0mm motor shaft for extra strength, as well as oversize ball bearings to support the shaft and provide a long life. The stators are made with 0.20mm laminations for maximum efficiency and minimum Eddy Current losses. Since these motors are typically soldered directly to the speed controller to save weight, the 2208 motors come without bullet connectors and feature extended pre-tinned motor leads that are 10 inches (254mm) long. These motors also have 3mm threaded holes in a 16x19mm pattern on the back plate for easy installation on your model.

The CM-2208 series motors feature an integrated 5mm threaded motor shaft which eliminates the chance of having a prop adapter spin off in flight. The included prop washer and nylon insert prop nut provides a solid attachment for your propellers that will not loosen up and slip during use.

Included with every Cobra CM-2208 Series Motor is a complete accessory package which contains the following items:

● Four M3x5mm Motor Mount Screws
● Four M3 Flat Washers
● Machined Aluminum Prop Washer
● Locking Prop Nut with Nylon Insert

Cobra CM-2208/20 Motor Specifications:
Stator Diameter : 22.0 mm (0.866 in)
Stator Thickness : 8.0 mm (0.315 in)
Number of Stator Slots : 12
Number of Magnet Poles : 14
Motor Wind " 20 Turn Delta
Motor Kv Value " 2000 RPM per Volt
No Load Current (Io) : 0.77 Amps @ 10 Volts
Motor Resistance (Rm) per Phase : 0.114 Ohms
Motor Resistance (Rm) Phase to Phase : 0.076 Ohms
Maximum Continuous Current : 20 Amps
Max Continuous Power (2-cell Li-Po) : 150 Watts
Max Continuous Power (3-cell Li-Po) : 220 Watts
Motor Weight : 44.2 grams (1.56 oz.)
Outside Diameter : 27.7 mm (1.091 in.)
Motor Shaft Diameter : 3.00 mm (0.118 in.)
Prop Shaft Diameter : 5.00 mm (0.197 in.)
Motor Body Length : 24.0 mm (0.945 in.)
Overall Shaft Length : 45.2 mm (1.780 in.)
Motor Timing : 5-10 degrees
PWM Frequency : 8 KHz